![]() If you didn’t happen to take a picture, and you’re not sure which wire goes where, immediately stop and call our plumbers. You don’t want any water escaping the tank.Īssuming that your tank has filled without any issues, refer to the photo you took earlier to safely reconnect all the wiring between the heating element and the water heater’s panel. It goes without saying, but if you notice any leakage around the heating element, you need to immediately turn off the intake, drain the water heater, and start over again. This will allow air to escape as the water heater fills. Go to your kitchen and turn on the hot water faucet. Check to make sure the drain valve is closed at the bottom of the tank, and then turn on the cold water intake. Your new heating element should now be securely in place. Watch: Replacing a water heater’s heating elementĬheck out this video to see what replacing a water heater’s heating element looks like. You need to find a happy medium here: you don’t want to overtighten (which will make getting this heating element off much harder next time), but you also don’t want the element to be too loose, which can result in leaks. We recommend you start by hand-tightening it, and then using the wrench to tighten it just a little further. Running your water heater element wrench clockwise, install the new heating element. Go ahead and position the gasket so that it forms a tight seal between the element and the tank. When you were removing the old one, you probably encountered the rubber gasket-or, at least, what remained of it after years of use. Now that you’ve removed the current heating element, it’s time to put in the new one. Related: Check out our water heater buying guide Putting in the next heating element This will ensure any remaining water is removed from the system before you proceed. To ensure the water heater is fully drained before you move forward, run the hot water tap in your kitchen. You might be familiar with this process if you’ve drained your water heater previously or replaced the water heater pressure-relief valve. This can be trickier, since many water heaters have the drain valve positioned relatively low to the ground. The second is to position a large bucket beneath the drain valve. The first is to attach a garden hose and run it somewhere outside. ![]() There are two ways to go about flushing out your water heater. Start by shutting off the water intake valve-this will ensure that no additional water comes into the tank while you’re working on it. ![]() Few homeowners ever reset the circuit for their water heater, so it’s possible that the exact circuit might be mislabeled in your breaker box. As a homeowner, you should have a multimeter handy for testing whether or not circuits are live-you’ll want to use it here. Start by taking safety precautionsīefore you do anything, you’ll need to turn off the power to your water heater, first at the knob and then at the circuit breaker. Obviously, you’ll also want to have a new heating element to replace the old one with, but you should also order a heating element rubber gasket, since there’s a good chance that your current one has deteriorated and needs to be replaced. Before you get startedīefore you get started, make sure you have the following tools: 1) a water heater element wrench, 2) a multimeter, 3) both a Phillips and flathead screwdriver, and 4) a garden hose. If, at any point, you don’t feel comfortable with the process, you need to stop and call one of our plumbers. As you can probably tell from the complexity of the instructions below, DIY water heater repair isn’t for everyone. In this guide, we’ll walk you through the DIY process for replacing the heating element in your home’s standard water heater. In this article, we’ll outline the steps for installing a new heating element and getting your water heater back up-and-running again. ![]() But, a failed heating element doesn’t necessarily mean you need to replace the entire water heater. If your water heater’s heating element fails, you’re going to be left without hot water. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |